Status Diagnostic Point
You can create a Status point for each cable connection for a configured redundant PLC. If configured, the point will be set to one of the following values:
Value | Description |
0 | OK–Indicates the enabler can connect to the PLC over this cable and the PLC has the expected state. |
1 | NOT OK–Indicates there is a problem with either the cable connection or the state of the PLC. |
2 | This cable is not configured. |
The addresses for the Status diagnostic points are:
$CONN_STATUS_P1C1 Status Point–Primary PLC over Primary Cable
$CONN_STATUS_P1C2 Status Point–Primary PLC over Secondary Cable
$CONN_STATUS_P2C1 Status Point–Secondary PLC over Primary Cable
$CONN_STATUS_P2C2 Status Point–Secondary PLC over Secondary Cable
$CONN_STATUS_P3C1 Status Point–Third PLC over Primary Cable
$CONN_STATUS_P3C2 Status Point–Third PLC over Secondary Cable