Data Source Diagnostic Point
You can create a Data Source point for each logical CIMPLICITY device in a redundant PLC configuration. If configured, the point will be set to one of the following values:
Value | Description |
0 | No communication on any cable |
1 | Current data is collected from the Primary PLC over the Primary Cable |
2 | Current data is collected from the Primary PLC over the Secondary cable. |
3 | Current data is collected from the Secondary PLC over the Primary Cable. |
4 | Current data is collected from the Secondary PLC over the Secondary Cable. |
5 | Current data is collected from the Third PLC over the Primary Cable. |
6 | Current data is collected from the Third PLC over the Secondary Cable. |
The addresses for the Status diagnostic point is:
$DATA_SOURCE | Data Source Point |