Square D SY/MAX Test Program

A stand-alone test program, sd_test.exe, is provided. This program provides direct communication between CIMPLICITY software and a SY/NET Network Interface Module, or between the CIMPLICITY software and a Programmable Logic Controller.

The test program can be used to:

• Verify port, network, and interface unit communication parameters.
• Verify line, network, and hardware functionality and operability.
• Directly access (for reading or writing) a specific PLC register location.
• Dump or clear some or all of the PLC user registers.
• Examine the send and receive message buffer content.
• Collect transmission statistics of the current configuration.
• Verify device information response.

You cannot use the test program while the CIMPLICITY Square D Communications enabler is running.

If the protocol for Square D is copyrighted or declared to be trademark or proprietary, or there are very restrictive conditions on copying the manual, obtain written permission from Square D to display the command or response buffers in the test program.