CIMPLICITYData Source Diagnostic Point
You can create a Data Source point for each logical CIMPLICITY device in a redundant PLC configuration. If configured, the point will be set to one of the following values:
| Value | Description |
| 0 | No communication on any cable |
| 1 | Current data is collected from the Primary PLC over the Primary Cable |
| 2 | Current data is collected from the Primary PLC over the Secondary cable. |
| 3 | Current data is collected from the Secondary PLC over the Primary Cable. |
| 4 | Current data is collected from the Secondary PLC over the Secondary Cable. |
| 5 | Current data is collected from the Third PLC over the Primary Cable. |
| 6 | Current data is collected from the Third PLC over the Secondary Cable. |
The addresses for the Status diagnostic point is:
| $DATA_SOURCE | Data Source Point |
