APPLICOM Device/Database Properties
- APPLICOM device properties
- APPLICOM database properties
APPLICOM Device Properties
When you configure a physical device on the APPLICOM protocol, use the APPLICOM properties to enter information about APPLICOM communications for the device. You can define the following:
Channel | Enter the APPLICOM channel ID for the device. The channel ID is an integer from 0 to 31. Channels 0 to 3 are on card 1, channels 4 to 7 are on card 2, etc. |
Equipment | Enter the APPLICOM equipment ID for the device as configured in PCCONF. |
Enable | Set this check box if you want the device to be enabled when the project starts. If you clear this check box, the device will not be enabled when the project starts, and points will not be available for this device. |
APPLICOM Database Properties
When you configure an APPLICOM Database, use the APPLICOM properties to enter information about the interface card. You can define the following:
Card | Enter the APPLICOM card ID for the interface card. The card ID is an integer from 1 to 8. |
Equipment | Not used. |
Enable | Set this check box if you want the device to be enabled when the project starts. If you clear this check box, the device will not be enabled when the project starts, and points will not be available for this device. |