Example 4.3.2. Enter Values for the Ratio Arrays

Procedure

  1. Stop the project; does a configuration update and re-starts the project.
  2. Open the Point Control Panel.
  3. Add the configuration array points for the Eliminate Sources Based on Rule function block.
  4. For each point:
    1. Double-click the point to open its Point Control Panel Point Properties dialog box.
    2. Enter a vae on the Detail tab.

    Note: The entered value is actually the 0 element in the array.

    Because there is only 1 element, the Array tab is not needed in the dialog box.

    1. Apply values to each parameter as follows
    Parameter Description Point Array Values
    Set Value Element
    1 Attribute Name MONITOR 0 MON_NAME
    2 Attribute Value 15 0 MON_VALUE
    3 Block Size 5 0 MON_BLOCKSIZE
    4 Block Limit 1 0 MON_LIMIT

Results

The values (Element 0) display in the Point Control Panel list.

The configuration for Eliminate Source by Ratio evaluation is almost ready for runtime. RSA will enter the count values during runtime.

Note: The weight that will be assigned to failures still needs to be entered in the Set Block Weights function block.

Attribute Name Attribute Value BlocK Size Block Limit Attribute History
MONITOR 15 30 20 TBD