Manually Register Dataflow Editor with Configuration Hub
This topic describes how to manually register and unregister Dataflow Editor with Configuration Hub.
Before you begin
- Ensure that security authentication source is configured for Configuration Hub.
- You should be an administrator to perform this task.
About this task
Procedure
- On the Operations Hub machine, open Windows Command Prompt.
-
Change the directory to the path where Operations Hub is installed on your system:
\Program Files\GE\Operations Hub\ node-red\
-
Run the following command replacing placeholder with actual values:
node.exe ch_reg_plugin.js <OPHUB_HOST> <HTTPS_PORT> <configHubContainerServiceBaseUrl> =<clientId>:<clientSecret> nodered
Placeholder Replace With <OPHUB_HOST> The primary host name you selected during install. <HTTPS_PORT> The port assigned to https protocol for Operations Hub. Typically it is 443
.<configHubContainerServiceBaseUrl> The base URL of the Configuration Hub Container Service. <clientId> Identifier of a client that has permission (authority) to register with Configuration Hub. <clientSecret> Client secret used to authenticate the client. For example,node.exe ch_reg_plugin.js ophubhost1.test.net 443 https://chhost:5000/container-svc/ =confighubadmin:itsSecret nodered
-
To unregister manually, you must run the following command before uninstalling
Operations Hub:
Note: If you registered manually, then you should also manually unregister. Uninstalling Operations Hub does not unregister if you did not choose to register during installation.Replace placeholder with actual values:
node.exe ch_reg_plugin.js <OPHUB_HOST> <HTTPS_PORT> <configHubContainerServiceBaseUrl> =<clientId>:<clientSecret> nodered unreg