Discovery Agent Selection Wizard - Select an RSLogix 5 or RSLogix 500 .EAS File
On the Select an RSLogix 5 or RSLogix 500 .EAS File page, you must select
the appropriate RSLogix exported address and symbol definition file (.EAS)
that you want to extract symbol information from. You can either enter
the full path of the file's location, or click the 
Browse
button to search for the file you want to use.
You also need to enter a name for the PLC you are extracting the symbol information for. The wizard uses this name to determine whether the PLC is a new device being imported into the project, or it is a device already existing in the project. The latter case can happen if you re-run the discovery agent to update an existing device. You can conveniently select the name from the drop-down list if it is an existing device in the project.
NOTE: You can extract symbols from only one EAS file a time. To extract symbols from more devices, rerun the Discovery Agent.
Click Next to go to the Summary page or click Back to return to the Select a Discovery Agent page.
NOTE: Click the Back button at any time to make changes to your selections.
