5. SPC Products: Variable Quality Characteristics

Information that you enter in the Variable Quality Control Characteristics dialog box is used to configure the selected chart set in the CimEdit/CimView ActiveX control.

Options include the following.

5.1 SPC Variable: Add a variable.
5.2 SPC Variable: General characteristics.
5.3 SPC Variable: Collection characteristics.
5.4 SPC Variable: Limits.
5.5 SPC Variable: Set alarms/Control tests.
CAUTION:
  • If numeric values are entered (e.g. on the Limits tab) during configuration and an inconsistency is detected, SPC will display an error message. You cannot save the configured data until the error is corrected.

Example

You select Values to enter a variable's control limits and enter 25 for an Upper Control Limit and 50 for a Lower Control Limit. SPC will display the following error message,

The upper control limit must be greater than the center line and the center line must be greater than the lower control limit.

  • If Point IDs are entered (e.g. on the Limits tab), SPC will alert the user when the values become specific at runtime. If SPC detects configuration inconsistencies, it will display an $SPC_ADMIN _ALARM in the Alarm Viewer.