Square D SY/MAX Test Program
A stand-alone test program, sd_test.exe , is provided. This program provides direct communication between CIMPLICITY software and a SY/NET Network Interface Module, or between the CIMPLICITY software and a Programmable Logic Controller.
The test program can be used to:
- Verify port, network, and interface unit communication parameters.
- Verify line, network, and hardware functionality and operability.
- Directly access (for reading or writing) a specific PLC register location.
- Dump or clear some or all of the PLC user registers.
- Examine the send and receive message buffer content.
- Collect transmission statistics of the current configuration.
- Verify device information response.
You cannot use the test program while the CIMPLICITY Square D Communications enabler is running.
If the protocol for Square D is copyrighted or declared to be trademark or proprietary, or there are very restrictive conditions on copying the manual, obtain written permission from Square D to display the command or response buffers in the test program.